This is the address that the router uses to connect to your cable or DSL service provider.
- Goa sex chat com
- whos audrina patridge dating
- Free sex chat to girls no cost no sighn up
- internet dating profile writer
- buzz50 dating
- time out new york dating sites
- black dating famous man white woman
In the DOS window, enter the command “ipconfig”, on a MAC enter the command “ifconfig”.
You will see the IPv4 address, the subnet mask and the default gateway.
This can only either start with 192.168 or 10…, so you know you are using an internal address if it starts with this.
To access the cameras remotely, you need it’s WAN address.
If it works you can use this to access your camera from anywhere in the world with one caveat, it may only last a few hours or at best a few days, so onto to the last step in the process.
STEP 4 Service providers have many, many customers and it would be very expensive to give each and every one of us a fixed IP address as you did with your camera in step 1.
The default is typically 80, but if you want to have more than one camera, you need to use a different number.
To avoid port conflicts, it’s better to use a number higher than 8000 but less than 60000.
Use this subnet mask (typically 255.255.255.0) and default gateway (the IP address of the router).